--- doc/loncapafiles/ntpcheck.piml	2004/05/19 16:04:12	1.1
+++ doc/loncapafiles/ntpcheck.piml	2004/08/23 19:07:26	1.5
@@ -1,9 +1,9 @@
 <!DOCTYPE piml PUBLIC "-//TUX/DTD piml 1.0 Final//EN" 
 	"http://lpml.sourceforge.net/DTD/piml.dtd">
-<!-- check_ntp.piml -->
+<!-- ntpcheck.piml -->
 <!-- Matthew Hall -->
 
-<!-- $Id: ntpcheck.piml,v 1.1 2004/05/19 16:04:12 matthew Exp $ -->
+<!-- $Id: ntpcheck.piml,v 1.5 2004/08/23 19:07:26 matthew Exp $ -->
 
 <!--
 
@@ -43,25 +43,25 @@ if (! -e "/etc/init.d/ntpd") {
 }
 my $value = `/etc/init.d/ntpd status`;
 if ($value !~ / running/) {
-    print "WARNING: npt is installed but is not currently running.\n";
+    print "WARNING: ntp is installed but is not currently running.\nPlease verify the configuration of ntp in /etc/ntp.conf and /etc/ntp/step-tickers\nStart ntp by executing\n /etc/init.d/ntpd start\n";
 }
 # chkconfig barfs to stderr if the target isn't set up right.
 my $restartchk = `/sbin/chkconfig --list ntpd 2>/dev/null`;
 if ($restartchk eq '') {
-    print "WARNING: ntpd is either not installed or not configured to run at boot.\n";
+    print "**** WARNING: ntpd is either not installed or not configured to run at boot.\n";
     exit;
 }
 if ($restartchk =~ /^error reading information on service / ||
     $restartchk !~ /\d:(on|off)/) {
-    print "WARNING: Unable to check status of ntpd with /sbin/chkconfig.\n";
+    print "**** WARNING: Unable to check status of ntpd with /sbin/chkconfig.\n";
     exit;
 }
 if ($restartchk !~ /\s3:on/) {
-    print "WARNING: ntpd is not set to start at runlevel 3.  To correct this run:\n/sbin/chkconfig --level 3 ntpd on\n";
+    print "**** WARNING: ntpd is not set to start at runlevel 3.  To correct this run:\n/sbin/chkconfig --level 3 ntpd on\n";
     exit;
 }
 if ($restartchk !~ /\s5:on/) {
-    print "WARNING: ntpd is not set to start at runlevel 5.  To correct this run:\n/sbin/chkconfig --level 5 ntpd on\n";
+    print "**** WARNING: ntpd is not set to start at runlevel 5.  To correct this run:\n/sbin/chkconfig --level 5 ntpd on\n";
     exit;
 }
 </perlscript>